X 303 base
von 3dDesignPrint
10
Downloads
2
Likes
0
Makes
A guy asked me to upload a mounting base to the X-303 stargate ship that printed. This is not exactly the same design but it will work the same.
https://www.thingiverse.com/make:277704
Instructions: Take a long M3 screw, cut off head with wire cutters, heat it up with a torch, melt a hole into X-303 print with it, pull it out leaving a hole, heat again if necessary, insert into base, let cool locking screw into base, then put X-303 onto screw.
https://www.thingiverse.com/make:277704
Instructions: Take a long M3 screw, cut off head with wire cutters, heat it up with a torch, melt a hole into X-303 print with it, pull it out leaving a hole, heat again if necessary, insert into base, let cool locking screw into base, then put X-303 onto screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!