Thingiverse
X axis end clamp
by bunjatec
2
Downloads
0
Likes
0
Makes
this clamps onto the end of the x axis to stop the rods pushing through allowing the belt to be tensioned.
requires 2x M3 nuts and bolts, the nut is retained in the Hex socket on the fixing
you will need to print :
1x end clamp
2x end clamp fixings
The clamp then holds the ends of the x stage rods and stops them poking out.
requires 2x M3 nuts and bolts, the nut is retained in the Hex socket on the fixing
you will need to print :
1x end clamp
2x end clamp fixings
The clamp then holds the ends of the x stage rods and stops them poking out.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!