X-Brace for Stackable AMS Shelf

DescriptionI noticed a lot of flex using the original braces for this print so created a larger X-Brace for far superior corner to corner support, only 1 X-Brace is required. It is also deeper allowing for the lid to open much wider for easier reel/desiccant swaps. Assembly instructions:Glue required to fix the arms to the central piece, I personally used Gorilla Glue. I also used glue on the built in pegs to fix to the AMS shelf itselfAdditional accessories:X-Clip (to hold AMS lid open) - https://makerworld.com/en/models/858106#profileId-807764X-Plugs (to fill redundant peg holes) - https://makerworld.com/en/models/858126#profileId-807784 Updates: 09/01/2025: reduced size of pins due to some comments on them not fitting, may now require the addition of glue to properly secure. Credits:MihaiDesigns for the original model on Thangs3DMON@3DMON_604296 for bringing the design to Printables@GekoPrime for the original Remix