Thingiverse
X-Carriage 3d-plexi-printer
von steijlen
13
Downloads
13
Likes
0
Makes
This is my X-Carriage (for the extruder) to be used in my new to develop 3d-plexi-printer.
It can hold a NEMA 17 motor and extruder.
It has a piece to act with an optical end stop.
It is made for 8mm steel rods and T2.5 timing belt.
It holds 4 linear bearings (24mm length x 16mm diameter x 8mm inside).
Just examine the file to see if you can use it.
For any questions please contact me.
It can hold a NEMA 17 motor and extruder.
It has a piece to act with an optical end stop.
It is made for 8mm steel rods and T2.5 timing belt.
It holds 4 linear bearings (24mm length x 16mm diameter x 8mm inside).
Just examine the file to see if you can use it.
For any questions please contact me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
