X-Carve reverse drag link bracket

I remade the bracket that the 1000mm X-Carve uses on the left side bottom and I am using it on my 500mm X-Carve. I also reversed it so that I can feed my cables out the back of the system.

I didn't like the way the 500mm X-Carve drag link chains were so I printed some of my own that were from the 1000mm version.

The model is the standard bracket. I just flipped the model in Cura so that I could get a reverse of it so that it was correctly oriented when I put it on the back rail.

You may have notice my front and back rails under the waste board are a bit longer and sticking out. I put longer rails in so the I could mount the X-Carve easier to my cabinet I made.