Thingiverse
X-Hydro
por JarlRhau
4
Descargas
1
Likes
0
Makes
Hydroponic parts for DIY Hydro system with sprayer. distributor and end caps to fit on 16 mm plastic pipe.
Sprayer16.7 is the sprayer to fit over a drilled hole on the 16 mm tube.
Sprayer 16.7 end cap to be fitted at the end of the 16 mm tube.
The distributor is intended to be mounted on a 16 mm standing tube on a pump
in whatever bucket you choose to build a hydro system of.
and if using distributor without pump as an extension a pulgged 16 mm tube is used.
The clamp to be fitted on any bucket railing to hold a plastic sheet with holes for whatever size of pots you choose to grow in.
Sprayer16.7 is the sprayer to fit over a drilled hole on the 16 mm tube.
Sprayer 16.7 end cap to be fitted at the end of the 16 mm tube.
The distributor is intended to be mounted on a 16 mm standing tube on a pump
in whatever bucket you choose to build a hydro system of.
and if using distributor without pump as an extension a pulgged 16 mm tube is used.
The clamp to be fitted on any bucket railing to hold a plastic sheet with holes for whatever size of pots you choose to grow in.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
