X-Plus 3 Bin v3

Modified version of TheNorthernLight's original design.

I've named this "V3" only because I've now printed two different designs that didn't fit on my apparently updated version of the QIDI X-Plus 3 (v2..?) printer purchased early 2024. The original version unfortunately hits on the bed shroud when the bed fully lowers for me, so there might be some tolerance issues between printer models or upgrades perhaps.

Anyway - I've made this version so that it sits under the door lip - you can also slide it in or out a few mm to suit your printer. I replaced the original pegs with some square dowels, which I suggest you print and glue or pressure fit depending on tolerances. Because the model is now no longer symetrical, you need to print one of each (they have been marked on one side). I also reduced the height of the floor to save on print time.

Please let me know in the comments if it works for you!