Thingiverse
X-Y Axis Calibration
von April1
1
Downloads
4
Likes
0
Makes
Calibration with a 20mm cube is not enough. This piece is 100x100 mm, good enough for calibration.
Print it on your printer and check the dimensions and change the feed rate as per following:
New feed rate = old feed rate * 100/actual measured length
******Please ensure that marked X side is parallel to X axis while slicing.
Print it on your printer and check the dimensions and change the feed rate as per following:
New feed rate = old feed rate * 100/actual measured length
******Please ensure that marked X side is parallel to X axis while slicing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
