X-Y-Compensation Tool

This tool is used to find the values for the X-Y hole and contour compensation.Important note:The test should ideally be carried out with PLA, as this filament has the lowest shrinkage rate and therefore delivers the best result.Filaments with a high shrinkage value such as Nylon (PA6, PA12), PP or ABS should not be used. This leads to falsification of the results without correction of the shrinkage factor.Print the tool and measure the dimensions of the tool. The dimensions are:Outer dimensions 100mm x 50mm x 5mmthe inner square 40mm x 40mmthe diameters of the holes are 30mm and 10mmThe test cylinder has the following diameters from bottom to top: 29.7mm, 29.8mm, 29.9mm for the large bore and 9.8mm for the small bore. Calculation formula: Nominal dimension - actual dimension = deviation > deviation/2 = compensation value Example:The measured value of the pressure of the long outer edge is 99.86mm. Target value is 100mmCalculation: 100 - 99.86 = 0.14 >0.14 / 2 = 0.07Your X-Y contour co