X2V2 Mini Zeromouse Inspired Mod

Remixed from https://**********.com/en/models/1592061-26g-pulsar-x2-v2-fingertip-mod#profileId-1676746 model.It weighs 27 grams fully built.I am new to CAD, so the model is a bit messy, but it is usable. If you redo the design to make it better, please remix it to improve the model."In order to assemble the mouse mod, first you'll need to disassemble the stock mouse. The teardown video below by Beardedbob is excellent for understanding how to fully disassemble the mouse. All you need from the stock mouse is 5 screws, the motherboard, and battery. Once you are able to remove the motherboard from the bottom of the stock mouse, detach the ribbon cable attached to the side buttons as this mouse does not make use of them. Leave the battery, switches, and encoder still attached to the motherboard unless you plan on doing further modifying of those pieces. Once the motherboard is free, insert it into the mouse from the front and slide the battery under both the diagonal and horizontal fingertip braces. The motherboard should fall into place on top of the 4 standoffs on the body. Use 4 of the screws and 4 washers to attach the the motherboard to the new body in each of the 4 corners as shown in the pictures above. Next, insert the scroll wheel stabilizer onto the motherboard. Just behind the scroll wheel, you'll see a square and a circular hole right next to each other. Simply match the shapes up on the bottom of the stabilizer and it fall into place. Use your last screw and washer to secure the stabilizer from the bottom of the motherboard. Once tightened, the cantilever on the right side of the scroll wheel should snap into place and your middle mouse click should work perfectly. Finally, attach the left and right triggers to the mouse body in the 2 vertical slots in the mouse body. Incase you get confused which trigger is which, the left trigger has a rectangular cutout to prevent the trigger from hitting the rotary encoder. The triggers should be a tight fit and should