Thingiverse
X328 Parts
di dogs10109
5
Download
5
Likes
0
Makes
Parts pack for the X328 FPV frame.
The motor adapters move the motors slightly out from the center allowing you to fit 9" props. I printed out of PLA and using 2212 motors they stay cool enough to not melt anything. I would recommend a more thermally resistant filament though. Add two M3 nuts per adapter and it uses the little opening on the end of the arm as a screw hole. I had to drill the carbon a little bit so the screw slides in without resistance.
The GPS mount/lid is based off this thing here: https://www.thingiverse.com/thing:3245309. For the 5883 GPS unit, the mount goes on the front of the quad under the FPV cam. So, the camera mounts are sized to allow it to fit. I also used a heat gun to allow the gps to bend down a little to reduce visibility from the camera; its not required though.
The antenna mount is off center to allow my XT60 plug to ziptie to the other half of the mount.
The motor adapters move the motors slightly out from the center allowing you to fit 9" props. I printed out of PLA and using 2212 motors they stay cool enough to not melt anything. I would recommend a more thermally resistant filament though. Add two M3 nuts per adapter and it uses the little opening on the end of the arm as a screw hole. I had to drill the carbon a little bit so the screw slides in without resistance.
The GPS mount/lid is based off this thing here: https://www.thingiverse.com/thing:3245309. For the 5883 GPS unit, the mount goes on the front of the quad under the FPV cam. So, the camera mounts are sized to allow it to fit. I also used a heat gun to allow the gps to bend down a little to reduce visibility from the camera; its not required though.
The antenna mount is off center to allow my XT60 plug to ziptie to the other half of the mount.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!