Slicer Discord
X5S Z support System – 3D-printbaar model van Thingiverse Thingiverse

X5S Z support System

door DKDaigle
229 Downloads
116 Likes
0 Makes
Model downloaden
Complete Rod, stepper, and Flat bed support system for stiffer Z setup.

To install you will need 24 - M4 x 10 screws and 24 M4 - 2020 T-Nuts, 4 - 8mm x 16mm or somthing simular for the two holes next to the lead screw to clamp it together to the flat plate in the middle.

I also suggest getting M3 x 45 screws to secure the z steppers. the factory lengths grabs but I cant imagine there is much holding it.

I printed these at .2 layers, 20% infill, and 3 wall layers and they are quite solid. On the bottom mount I printed it at 5 top and bottom layers also and that forces the thin middle part to be a solid piece of plastic. Your call on weather you do or not.

You can use this without the bottom stepper stiffners, and use the factory bolts. I run a timing belt between the steppers to sync them and didnt want them to have any play though.

Edit, if your running a belt between steppers and use this z system with the pullies on the steppers this should fit just right.

Upda
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie