Thingiverse
X5sa frame legs
door oredith
40
Downloads
32
Likes
0
Makes
Just a simple riser for the Tronxy X5sa. I needed to lift it up high enough for me to put the stock power supply, and the new BTT Octopus board under the printer. I also designed it with 1/4-20 threaded hole to make use of swivel feet I already had around the house.
https://www.amazon.com/CSFMC-Furniture-Adjustment-Installation-Protection/dp/B0B2WR4L93/
the risers are held on by M5x12 socket head caps and t-slot nuts. I used these because i had a bag full of em around. they are a snug fit in 2 of the openings, but they DO fit, it's just very tight tolerance. you should NOT have to use actual pressure to get it to fit, just wiggle it in.
https://www.amazon.com/gp/product/B08MZLJMMV/
alternatively, you can get some M5x10, and it should fit without a problem.
https://www.amazon.com/CSFMC-Furniture-Adjustment-Installation-Protection/dp/B0B2WR4L93/
the risers are held on by M5x12 socket head caps and t-slot nuts. I used these because i had a bag full of em around. they are a snug fit in 2 of the openings, but they DO fit, it's just very tight tolerance. you should NOT have to use actual pressure to get it to fit, just wiggle it in.
https://www.amazon.com/gp/product/B08MZLJMMV/
alternatively, you can get some M5x10, and it should fit without a problem.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
