Thingiverse
Xacto Knife Cap
por Micron_Nanotech
3
Descargas
0
Likes
0
Makes
I whipped this up on TinkerCad to replace the cap I lost on my old Staedtler blade.
If it's too loose or too tight, just edit the ID. Everything else should work fine.
If you do remix it, I'd suggest to make the id at the opening slightly smaller so it grips better.
I printed it upside down in PETG and it printed fine with no support.
If it's too loose or too tight, just edit the ID. Everything else should work fine.
If you do remix it, I'd suggest to make the id at the opening slightly smaller so it grips better.
I printed it upside down in PETG and it printed fine with no support.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!