Xbox Controller Circuit Case

This is a "case" for the circuit of a PowerA Wired Xbox 1 Controller.
There is a slit to place a stopper to keep them in place because the parts keep shaking and the circuit doesn't stay still (This only happened on my "bad" printer; if your printer is really accurate you shouldn't really have to use this) There are studs on the bottom plate to attach the lid, but I've noticed the top doesn't fit so you can just remove those and it will work fine, but it might slide off (or you can remove 2-3mm off the end of the base and continue with the studs)
NOTE:
This is designed ONLY for the wired PowerA Xbox controller. It will not work on other models.
You may have to add a little bit on top of the platforms on the base (I just used hotglue) because they are too small for the controller.