Thingiverse
Xbox Controller hanging Holder
von Gerrit259
47
Downloads
73
Likes
0
Makes
Hello,
I am new to 3D printing and this is my first thing I am uploading.
I wanted to hang my controller so I quickly designed this hanging holder and printed it.
It works very well. The game pad cannot fall out easily due to the angle.
To mount version 1.1 you are supposed use a good double-sided tape. This works for me so far. However, if you want to be on the safe side you should print version 1.2 where I added two 4mm holes for screws.
Edit: I just added a logo to both versions.
I am new to 3D printing and this is my first thing I am uploading.
I wanted to hang my controller so I quickly designed this hanging holder and printed it.
It works very well. The game pad cannot fall out easily due to the angle.
To mount version 1.1 you are supposed use a good double-sided tape. This works for me so far. However, if you want to be on the safe side you should print version 1.2 where I added two 4mm holes for screws.
Edit: I just added a logo to both versions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
