Thingiverse
Xbox Headset and Controller Wallmount
por TorayIntern
19
Descargas
14
Likes
0
Makes
Material:
PLA or PETG
Settings:
At minimum, 3 walls with a 0.4mm nozzle diameter since this will be a loading bearing part
Recommended minimum 15% infill however infill doesn't contribute too much to part strength
Whatever speed your printer can handle
Increase flow rate or line width if you want a stronger bond but reduced dimensional accuracy
No supports, slice and print xbox logo face down. Keep in mind any imperfections on your printerbed will also cause defects in the final part.
Assembly:
Acyrlonitrile glue or wood glue on the xbox plate and secure to wall plate. Allow any physical glue like wood glue to dry atleast 24hrs before use. Use clamps. Acyrlonitrile glue only needs approx. 5min to dry before unclamping.
Use 25lb loading bearing dry wall screws to mount the plate to a wall
PLA or PETG
Settings:
At minimum, 3 walls with a 0.4mm nozzle diameter since this will be a loading bearing part
Recommended minimum 15% infill however infill doesn't contribute too much to part strength
Whatever speed your printer can handle
Increase flow rate or line width if you want a stronger bond but reduced dimensional accuracy
No supports, slice and print xbox logo face down. Keep in mind any imperfections on your printerbed will also cause defects in the final part.
Assembly:
Acyrlonitrile glue or wood glue on the xbox plate and secure to wall plate. Allow any physical glue like wood glue to dry atleast 24hrs before use. Use clamps. Acyrlonitrile glue only needs approx. 5min to dry before unclamping.
Use 25lb loading bearing dry wall screws to mount the plate to a wall
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!