Thingiverse
Xbox Logo 3D
por Hawkitch
12
Descargas
10
Likes
0
Makes
You will probably be happier with my other Xbox logo because this one is half spherical so it has a small viewing angle. The one in the link is flatter so it has a much bigger viewing angle. https://www.thingiverse.com/thing:6297184
The front lobe is bigger to make the proportions correct when viewing from above. One model has a base, the other model is four separate parts. Designed with Onshape. Print took 6 hours, 0% infill, high resolution, Ender 3 pro, Geeetech Silk silver PLA. A hole was drilled in the back for a LED. Digikey RL5-B2545 Blue LED. Runs off 5V usb with a 51 ohm resistor to give ~30ma.
If you light it please post a make with the details.
The front lobe is bigger to make the proportions correct when viewing from above. One model has a base, the other model is four separate parts. Designed with Onshape. Print took 6 hours, 0% infill, high resolution, Ender 3 pro, Geeetech Silk silver PLA. A hole was drilled in the back for a LED. Digikey RL5-B2545 Blue LED. Runs off 5V usb with a 51 ohm resistor to give ~30ma.
If you light it please post a make with the details.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
