Thingiverse
Xbox One Controller Holder
por niall_cooley
6
Descargas
1
Likes
0
Makes
I printed this with zero top and bottom layers and a 20% triangular infill at 0.3 layer height.
The reason i used no tope and bottom layers was so the infill pattern could be seen at the sides.
The reason i used no tope and bottom layers was so the infill pattern could be seen at the sides.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
