Thingiverse
Xbox One Controller Stand 1 inch pegboard
by TyrSniper
1
Downloads
4
Likes
0
Makes
This is a remix of a skadis pegboard mount (thank you to the creator!)
I added an additional centered peg and included a 1 inch pegboard peg.
THE HOLES ARE NOT EVEN. A controller can be held up using ANY of the three. I am hanging some of the mounts off the edge of the pegboard so I'm using the left and right side holes.
This is meant to be held up by a single peg in the center, the 1 inch hole peg is included.
I added an additional centered peg and included a 1 inch pegboard peg.
THE HOLES ARE NOT EVEN. A controller can be held up using ANY of the three. I am hanging some of the mounts off the edge of the pegboard so I'm using the left and right side holes.
This is meant to be held up by a single peg in the center, the 1 inch hole peg is included.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
