Thingiverse
Xbox power brick wall mount
by johnabassian
56
Downloads
37
Likes
0
Makes
Wall mount for mounting an Xbox One/360 power brick on the wall. Designed for easy removal from wall mounted screws, maximum airflow, and minimum filament.
Printed with 20% fill density and .3mm layer height.
edit: Whoops, I'm a moron. The hole on the bottom is too small for the connector to go through, need to adjust. Do not print this until I get v2 uploaded.
v2: square hole on the bottom big enough to fit the connector. If you've printed v1 already, just use a hair drier to heat the bottom, and fan it out enough to fit the connector through it.
Printed with 20% fill density and .3mm layer height.
edit: Whoops, I'm a moron. The hole on the bottom is too small for the connector to go through, need to adjust. Do not print this until I get v2 uploaded.
v2: square hole on the bottom big enough to fit the connector. If you've printed v1 already, just use a hair drier to heat the bottom, and fan it out enough to fit the connector through it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
