MakerWorld
Other Toys & Games
Ver Modelo
Xbox Stick Savers
185
Descargas
52
Likes
128
Makes
SummaryThese Stick Savers are meant to be attached to the thumbsticks of an Xbox controller to prevent movement (and hopefully any potential damage) while transporting the controller in a bag. These are a remix of the Joystick Savers by Skylancer. I ended up remodelling them from scratch mainly to smooth out the "wings", but also to build the hex filler pattern into the model so I didn't have to use a specific slicer or mess with removing top/bottom layers and adjusting the filler in the slicer. I've taken my controller with me on a couple trips and so fare these have done a great job of preventing the thumbsticks from moving at all, so I can only assume they're also preventing potential damage as well.Print SettingsPrinter: Ender 3 v2 Rafts: No Supports: No Resolution: 0.20 Infill: 100%Post-PrintingAfter printing, they can be a little stiff to begin with, so I just used them like fidget toys while working and connected/disconnected them a hundred times until they l
Jargs también publica en
16 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!