Thingiverse
Xbox Wireless Receiver Holder
von Rapidhearts
11
Downloads
5
Likes
0
Makes
Made this Xbox Wireless receiver holder for my pc as I was sick of it
falling off my desk and losing it.
I put a clip at the front for the usb plug so it was easy to find after
using the usb port for other things. The gap for the clip to hold it
to the desk is 17 mm.
It takes about an hour and 6 minutes to print with 20% infill, 2 shells and a raft. Supports are needed for the desk clip.
falling off my desk and losing it.
I put a clip at the front for the usb plug so it was easy to find after
using the usb port for other things. The gap for the clip to hold it
to the desk is 17 mm.
It takes about an hour and 6 minutes to print with 20% infill, 2 shells and a raft. Supports are needed for the desk clip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
