xFlasher Case (USB C)

This case was designed for the xFlasher 360 (an all in one Xbox 360 NAND reader/writer)It was created with injection molding in mind so the tolerances are very tight. To print this you will need a high resolution SLA printer. For lower resolution printers try the no clips version of the case. For the no clips version you should add a drop of superglue to each corner of the case and hold until set.If printing the version with clips you should start with the larger clip and use it as a hinge to lay the top half down. After, firmly press in each of the two smaller clips until the case is fully closed.For the non USB C version you'll want this case: Original xFlasher case