Xiaomi Vacuum Bot Lid Hinge

Recently, our Xiaomi vacuum robot took a flight down the stairs due to a very stupid corner in the staircase. Surprisingly, the robot was okay, just one hinge of the lid and the bumper broke. So I took the good hinge, measured it, and printed two new ones. They fit perfectly and are just a tad stiffer than the original ones.

Print the hinge on its side for strength.
These parts are small, so use .1 mm resolution and a brim, and print slowly. Also, supports are needed.

To make two, you need to mirror this one! The hinges are not symmetric.

You can find the bumper part here:
https://www.thingiverse.com/thing:3035365