Thingiverse
Xmaxx Battery Holders -Increased Height
by joshy788
38
Downloads
14
Likes
1
Makes
1st Creation.
I wanted Hardcase Li-Po Batterys and they always seems a tad tall.
The tested Hardcase lipos i used are
SMC 4 cell Hardcase 8000mah 120C batterys
These holders increase the bar by 2.5mm allowing a .5mm gap between the bar and battery.
Suggested to add a foam strip, so that helps the sudden impacts that could crush the case caused by the pressure of the bar and the case.
I wanted Hardcase Li-Po Batterys and they always seems a tad tall.
The tested Hardcase lipos i used are
SMC 4 cell Hardcase 8000mah 120C batterys
These holders increase the bar by 2.5mm allowing a .5mm gap between the bar and battery.
Suggested to add a foam strip, so that helps the sudden impacts that could crush the case caused by the pressure of the bar and the case.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!