Xmod Modified chassis for modern electronics

This is a custom Xmod chassis to make installation of modern electronics easier. This was designed around very specific parts (listed below), if you use different items, adjustments may need to be made. Further complicating things, this was designed for the medium length chassis configuration, and the short and long options were not included. The fusion 360 files are included to help with changes that may be necessary.

All parts were printed at 0.20 layers.

Front brace - supports needed, pause at layer 20 to switch colors (optional)

Rear brace - no supports

ESC strap - no supports (you could skip printing this all together and hot glue ECS into place)

ESC&servo holder - supports needed

Chassis (2 printing options)
Print with logo inlay
bottom logo - print with no supports, pause after layer 2, stop print when paused, change colors, then print "chassis-bottom logo"
chassis-bottom logo - print with supports, and z hop when retracted set at 0.5mm. see this vide