Thingiverse
XT 60 connector mount
door nifty1a
86
Downloads
57
Likes
0
Makes
Mount to hold a XT60 connector onto the back of a 250 size quad.
If you want one to mount on the other pillar, simply mirror the stl in your slicer program
The test prints were done by Adam at https://instagram.com/sendtohim3dprints/
Added filleted edges
Opened out terminal clearance holes to 5.5mm
Added two different length versions, 2.5mm offset for side mounting, 6mm offset for rear mounting.
(These are untested yet)
If you want one to mount on the other pillar, simply mirror the stl in your slicer program
The test prints were done by Adam at https://instagram.com/sendtohim3dprints/
Added filleted edges
Opened out terminal clearance holes to 5.5mm
Added two different length versions, 2.5mm offset for side mounting, 6mm offset for rear mounting.
(These are untested yet)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
