XT30 x 3 power strip

Power strip for installing three XT30 female connectors. I use mine to connect three sets of LED-strips in my RC airplane. One for each wing half and one for the fuselage. But can of course be used for any application, where you want a little power strip for three XT30 connectors. Box outer dimensions is 37 x 22 x 12 mm. There is a 33 x 18 x 8 mm pocket inside the box. So plenty of room for wires, solder and perhaps a small set of components too. Hole for cable is 3 x 5 mm. The lid has a snap-fit: Look closely on the protrusions on the lid, one side of them has a small chamfer. The chamfer should be pointed down for easy closing and harder opening. Easy to pry box open with a small screwdriver into the wire hole.The random XT30 connectors I got has a slight press fit into the lid, but I guess that might vary slightly between different brands. If you hold the wires down with a spring clamp while soldering, like in my picture, the lid will melt slightly where the wires touch it. So perha