xt60 connector retaining clips

After putting my latest upgrade into my ctc replicator dual I needed to design a wee clip to hold the hbp power cable connector in place ( I hate cable ties - zip ties ) so I rattled 2 little clips up that can either be bolted or screwed in place to stop the connector and wiring moving about. The connectors are high amp model rc connectors "XT60" ones from an ebay supplier so that if I need to remove the hbp from the bot I can break the connector apart otherwise it was going to be hardwired (not a good idea). My bot seems to eat the power and ground lines to the hbp on a monthly basis so it was time to resolve this permanently with 15amp DC silicone coverd wire and an XT60 connector.

The hex nut is for an M3 nut and the countersunk hole is for an M3 countersunk bolt or a small screw head.