Thingiverse
xt60 holder
by ddongho2
6
Downloads
2
Likes
0
Makes
It was made in the form of a screw.
A plastic washer goes in the middle.
Insert the xt60 from the inside and fasten it in the shape of a nut.
If there is a gap depending on the thickness of the top plate, you can adjust the gap with a washer.
The perforation should be about 23mm.
A plastic washer goes in the middle.
Insert the xt60 from the inside and fasten it in the shape of a nut.
If there is a gap depending on the thickness of the top plate, you can adjust the gap with a washer.
The perforation should be about 23mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!