XT60 Plug Easy Grip

I converted my son's Peg Perego John Deere tractor to XT60 plugs and made this gripper so he could easily connect/disconnect his electric car from the charger; the factory connector was even hard for my wife to press and use. He absolutely loves it.

This is a "universal" plug: the depth will accept both the male and female XT60 plug. If requested I will create different grips for male or female, but honestly I did not think it necessary. Just hold the plug and superglue.

This is easy to print in any material: print with the text-side down, no supports. Resolution is up to you. There is a little wiggle room to accommodate slight differences between XT60 vendors, but glue makes up the gap.

How to: print; then use super-glue to hold it to the plug. If you want to go overboard, use some quick-set epoxy on the back end where the wires pop out.

My first-grader loves that he can now drive up and "refuel" his own electric tractor.