Thingiverse
XT60 Plug Housings
by timkrins
2.6k
Downloads
2.2k
Likes
2
Makes
A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing).
Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements.
I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not all connector brands may be the same.
No supports needed.
SAFETY: Please please keep in mind that you should solder your connectors really well. With these covers you won't be able to see if the wire might have come loose inside - so it is probably still safer to individually heat shrink the connections, especially if you are sending a lot of unfused current down them.
Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements.
I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not all connector brands may be the same.
No supports needed.
SAFETY: Please please keep in mind that you should solder your connectors really well. With these covers you won't be able to see if the wire might have come loose inside - so it is probably still safer to individually heat shrink the connections, especially if you are sending a lot of unfused current down them.
timkrins also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
