Thingiverse
XT60 surfaces bracket
von m4RT1n
157
Downloads
124
Likes
1
Makes
just a little mount for a XT60 so i can put it on the top plate of my quadcopter.
it is really simple and a 10 min print. the holes are for 3mm screws.
- push the xt60 together a bit and push it inside from the downside till it snaps in
here you can find colored XT60´s
- Bangood - XT60 orange
- Bangood - XT60 red
- Bangood - XT60 black
have fun...
if you like it please FOLLOW me or/and give it a LIKE :) , thx
it is really simple and a 10 min print. the holes are for 3mm screws.
- push the xt60 together a bit and push it inside from the downside till it snaps in
here you can find colored XT60´s
- Bangood - XT60 orange
- Bangood - XT60 red
- Bangood - XT60 black
have fun...
if you like it please FOLLOW me or/and give it a LIKE :) , thx
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
