Thingiverse
XT60H Panel Mount
door robbbo
3
Downloads
0
Likes
0
Makes
Remix of devsfan1930 design.
I changed the design slightly so that it would fit in any wall, and you wouldn't need to modify the design to account for wall thickness.
Procedure:
-Route wires through back piece first, then solder XT60H connector.
-Push XT60 connector into front piece.
-Push back piece firmly against front piece, and use soldering iron to plastic weld them together tightly. You can also use small screws to join the pieces together.
-Drill 1" hole into wall
-Install assembly using 2 appropriate screws.
I changed the design slightly so that it would fit in any wall, and you wouldn't need to modify the design to account for wall thickness.
Procedure:
-Route wires through back piece first, then solder XT60H connector.
-Push XT60 connector into front piece.
-Push back piece firmly against front piece, and use soldering iron to plastic weld them together tightly. You can also use small screws to join the pieces together.
-Drill 1" hole into wall
-Install assembly using 2 appropriate screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
