Xteink X4 case

Case for XTEINK X4 e-book reader.

Hinged, magnets holding it closed, transparent cover for the screen area, buttons available, e-reader attached to Magsafe ring in the case. Screen is protected from smudging and dirt but you can read it without taking it out of the case, nav buttons exposed, power button and all sockets protected. The screen cover is made from common transparency (comb-binding front cover), you can use any thin transparent plastic, and if it scratches, just replace it.

XTEINK X4 is ESP32 based, [custom open-source firmware available](https://github.com/crosspoint-reader/crosspoint-reader) and fully hackable.

FreeCAD project attached, parametric, so you can change a lot from spreadsheet.

Artifacts list:

1mm wire, about 24cm.
2x1mm magnets, 8pcs
A sheet of transparency or plastic packaging.
Magsafe steel ring (two are included with the ebook reader).
Cyanoacrylate glue (superglue)
Some common glue that doesn't leave vapor (rubber-cement?)
Optionally regular paper