Xtool S1 laser cable protector

My Xtool S1 laser sits on a moveable cart and the cables are subject to being pulled out or even broken. The accessory connectors are very flimsy.

I made these covers that attache to the back of the laser by removing one screw at a time and replacing with a 3mm x 20mm self tapping screw. Use a washer with each
screw. I wouldn't take all the screw out at once as what it holds might move.

You can put the cables through the holes or just cable tie them below.

If you don't what to remove the screws you could use strong double sided tape to mount the protector.

Cheers
Kisssys