XU1541 Enclosure

A quick design for an enclosure for the Commodore 1541 floppy drive to usb adapter (better known as an xu1541). It's a snug fit, so you might need to sand some parts a little bit (I had to sand the two extruding front bits on the front just a little bit). The top and bottom are also not completely flush, this was done on purpose to make it a little bit easier to pull apart if necessary (but again, it's a very snug fit, so taking it apart might still be somewhat difficult). Finally, as is visible in the print, the top has the C64 logo on it. Therefore supports for the top might be needed (I'm not certain, but, just to be on the safe side, they were enabled on my print).