Thingiverse
Xuav clouds rear hatch stop
door Romat
5
Downloads
2
Likes
0
Makes
Whilst building the Xuav clouds I noticed when I tightened down the screws on the rear hatch it was pulling the entire hatch below the airframe which I didn't like, I designed this small hatch stop to stop this happening.
I then found out the front hatch was also doing this and so printed another 2 to correct that.
small amount of support is required due to sharpness of the point but other than that no issues.
I then found out the front hatch was also doing this and so printed another 2 to correct that.
small amount of support is required due to sharpness of the point but other than that no issues.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!