XY 90 Microphone Mount

This is a remix of panevalentin's XY90 Microphone Mount which I found to be useful, but I had a few problems with the scale and other dimensions.

I made the bottom piece into the same wedge shape as a Shure microphone so it will fit a standard clip. I also separated the mics holder from the clip piece, so it is easier to print without support, and then just glue the pieces together. If you print without support, it might still be a little stringy on the bottom, but not a big deal.

I found this fits my overhead mics from my Samson 7 Kit (drum mic kit), allowing me to use a single mic stand instead of two.

You might want to scale it up to about 1.04 if you are printing with ABS.