Thingiverse
xyz rod guide
por deanosid
6
Descargas
2
Likes
0
Makes
I have the xyz 1.0 and the wobble that comes from the z axis is ridiculous.
This is my first attempt at reducing this wobble.
It is designed to drop through the top hole and I used a m4 nut and bolt to hold in place.
The centre hole picks up the threaded bar to stop the wobble.
WARNING
Try some 8mm threaded bar through the hole first as its tight and when the bed is rising the pla can get tapped by the bar and grind it to a halt.
This is my first attempt at reducing this wobble.
It is designed to drop through the top hole and I used a m4 nut and bolt to hold in place.
The centre hole picks up the threaded bar to stop the wobble.
WARNING
Try some 8mm threaded bar through the hole first as its tight and when the bed is rising the pla can get tapped by the bar and grind it to a halt.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
