Y.A.B.E.

Y.A.B.E.
===
Yet Another Bowden Extruder
---


This is jet another 1.75mm bowden extruder.. Inspired by the BT extruder but using a regular drive-gear (flashforge type extruder gear) and v-groove bearing.

The design goal of this extruder are as follows:
---
* 1.75mm filament
* bowden setup (direct drive version may follow later)
* ease of use
- easy access to drive-gear without disassembly
- ease of loading and unloading
* confined filament path
* use of readily available components


There are 2 levers available, one using a simple pin (as in the BT extruders), the others uses a M3x8mm screw with a head height of no more than 2mm (i used a Philips head screw)

Any suggestions for improvement are welcome.