Y bearing bracket

The original bracket by Alekseev_D made the bottom of my belt rub on the bottom rod (using a 608 bearing), so I created this variant to move the bearing up a bit. 4mm up was enough for me. I also created the attached belt clamp spacer (a variant on Prusa's belt clamp file) to move the belt attachment point up 4mm to make it so it will pull absolutely straight. It's also parametric so you can make the spacing different.

This allows mounting the bottom Y carriage "upside-down" which gives more Z travel by utilizing otherwise wasted space under the printer. This also eliminates one 608 bearing and the associated nut and washers. It does add one bolt. In all the vitamin count is reduced including one bearing.

EDIT: I wound up not using this configuration because I have an oversized pyroceram (high temperature glass) print bed which collides with my triangle vertices when the print bed is mounted this low. I also am at the limit of my threaded rod and can't widen the chassis an