Thingiverse
Y Smoke splitter
by James_R5D4
21
Downloads
15
Likes
0
Makes
Thought I'd create a Y splitter fitting to distribute the smoke better. Two pipe tubes can be attached to different locations.
The holes are dia 6.3, after printing tho the hole is only dia 5.23
The tube I'm using is dia 6.25
My tube is a push fit so this drop in diameter doesn't bother me. If it is a problem for your tube, just carefully use a heat source to soften the filament and push your tube into the hole.
My first print was still warm when I forced the tube into the hole, and it opened it up.
The holes are dia 6.3, after printing tho the hole is only dia 5.23
The tube I'm using is dia 6.25
My tube is a push fit so this drop in diameter doesn't bother me. If it is a problem for your tube, just carefully use a heat source to soften the filament and push your tube into the hole.
My first print was still warm when I forced the tube into the hole, and it opened it up.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
