Y tensioner for Ghost5 3D printer

Belt tensioner for Flying Bear Ghost 5 3D printer. Needed a skrew and a nut (M3).

You have to be very careful where you put this tensioner, so as not to hit the pulleys and not to reduce the stroke of the Y carriage

There are 2 parts, for each belt, which are basically mirrored, so that the open side is always towards the inside of the printer. The nut must be mounted on the part of the rear belt tensioner, so that it is possible to act on the screw to tighten. It is advisable to use a Phillips head screw.

Enjoy !