yagi antenna handle

Handle for tape measure yagi antenna used in amateur radio fox hunts. You have 2 printing options.

Option 1: You can print just the handle and an HT holder

Option 2: If you have the kc9on offset attenuator, you can print the handle and a holder for the offset attenuator

The holes are for #4-40 x 1.25" machine screws and nuts. Most hardware stores carry them. The PVC pipe is 1/2 inch.

The offset attenuator is found at: https://kc9on.com/product/fox-hunt-offset-attenuator/

Option 1:

1. print foxhunt_handle_5_4b2_handle.stl - this is the handle you hold
2. print either foxhunt_handle_5_4b1_ht_mount.stl or foxhunt_handle_5_4b2_ht_mount.stl

One holds the radio at an angle, the other is flat.

Option 2:

1. print foxhunt_handle_5_4b2_handle.stl - this is the handle you hold
2. print offset_attn_base.stl - attaches to the handle and holds the offset attenuator
3. print offset_attn_lid_with_ht_mount.stl - lid for the base