Thingiverse
Yamaha MT09 Side Toolbox
von SjorsKe
3
Downloads
7
Likes
0
Makes
Made this toolbox to snugly fit in the side of the frame. It contains a CO2 pump, 2 CO2 cartridges, and tire repair kit.
Box is made of TPU to not damage the frame and to be flexible enough to push in so it latches between the frame tubes. The lid is printed in PLA to give strength to the box. The lid sits in the inside.
All printed without supports and fitted on a 220x220 print bed.
The strap I used is extra (piece of mind), as you need quite some force to get the box out.
Note: as you can perhaps see on the photos, the box had a bit of warping. Not intended, but worked fine for me with additional curves.
Box is made of TPU to not damage the frame and to be flexible enough to push in so it latches between the frame tubes. The lid is printed in PLA to give strength to the box. The lid sits in the inside.
All printed without supports and fitted on a 220x220 print bed.
The strap I used is extra (piece of mind), as you need quite some force to get the box out.
Note: as you can perhaps see on the photos, the box had a bit of warping. Not intended, but worked fine for me with additional curves.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
