MakerWorld
Other Hobby & DIY
Zum Modell
Yarn Holder
757
Downloads
404
Likes
436
Makes
Most yarn holders my wife found were vertical and she wanted one that was horizontal so she asked me to design one. Very simple design. You print out the base, and two side pieces and snap them together. The inner spool is meant to protect the ball of yarn and spin on the 3/8 inch dowels (sold separately). I used 12 inch dowels and just cut them to length. For the print I used PLA with 4 perimeters for strength and 20% infill (base and side pieces). For the inner spool I printed it vertically with a brim, 15% infill and 2 perimeters and that seemed to work well.
BooBoo28 veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!