Thingiverse
yarn holder
door tartaglia3
0
Downloads
0
Likes
0
Makes
whatever you put on this will be able to freely unwind without rolling everywhere
only hardware needed is a 608 bearing
support is only needed on the top half
updated 14/9/2025: added a v2 for the bottom half with an angle since i ran into the part that goes into the bearing breaking off
only hardware needed is a 608 bearing
support is only needed on the top half
updated 14/9/2025: added a v2 for the bottom half with an angle since i ran into the part that goes into the bearing breaking off
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
