Yarn Winder (Remixed)

It is a remix of the Printable Wool Winder by matthewlaberge. Found here: https://www.thingiverse.com/thing:13816

I changed some hole sizes to allow for fewer sized hardware needed.

You will need:
Qty: 6 - 608 Bearings
Qty: 2 - 6x13x5mm Bearings

Qty: 2 - M8 threaded rod. (Determine length based on how thick your base is.)
Qty: 1 - M8 x 55mm Machine Screw
Qty: 4 - M8 Hex Nut
Qty: 2 - M8 Nyloc Hex Nut
Qty: 5 - M8 Flat Washer
Qty: 3 - M6 x 40mm Machine Screw
Qty: 3 - M6 Lock Nut
Qty: 2 - M6 Flat Washer

Qty: 4 - Rubber Bands


I bought my 608 Bearings at a skateboard shop. I purchased the Cheapshots which were $13 for 8. I bought my 6x13x5mm Bearings at the RC/Miniature hobby store. All hardware was purchased at a small local hardware store. The rubber bands I used are from Dollar General. I twisted three rubber bands to use as the bumper to cause friction between the Drive Cone and the Spindle Base. The forth rubber band I used between the driver and driven pulli